Missing shingles after a wind event
We tarp the exposed area the same day, then match and install replacement shingles once the storm passes. If the field is more than 20 percent damaged, we price a full re-roof so you can compare.
Our roofing installers Cutler Bay FL crews handle full tear-offs, re-roofs and new construction across Miami-Dade County. We install GAF Timberline and Owens Corning Duration shingles, standing-seam metal panels and clay tile - all fastened to Florida Building Code and Miami-Dade County NOA specs. If your roof is 15 years old or you lost shingles in the last blow, we give you a same-day written estimate and a straight answer on repair versus replacement.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (855) 960-5906 → No spam. No obligation. Just practical help.
Roofing installers Cutler Bay FL work is more than nailing down shingles. A proper install starts with stripping the old roof down to the deck, replacing any rotted sheathing, then laying ice and water shield at the eaves and valleys before roofing felt goes down. We set roof flashing at every wall, pipe boot and chimney, then fasten the field with a roofing nail gun at the manufacturer's pattern. Ridge caps, drip edge and sealant finish the job. Get the underlayment wrong and you will be chasing roof leaks for years.
Cutler Bay sits in a high-velocity hurricane zone, so your roof has to hold up to 140-plus mph wind uplift and salt air off Biscayne Bay. Most homes here are 1,500 to 2,800 square feet with low-slope or 4:12 to 6:12 pitched roofs, and a lot of them still carry original 2004-era shingles. If you have been searching for roof installers near me Cutler Bay FL after a storm, we can usually get an inspector on your roof within 24 hours.
Every full installation we sell covers the whole roof assembly, not just the visible surface. Here is what is standard on a Zyntix Forge Works install, and what we price separately when your roof needs it.
We strip the old roof down to the deck, load every bundle into a dumpster and haul it off site. Disposal fees and dumpster placement are included in the quoted price, not added later.
We check the sheathing for rot, delamination and soft spots, then replace damaged panels with like-thickness plywood before anything goes back down. Rotted decking is the number one hidden cost on a re-roof.
Ice and water shield goes at the eaves, valleys and around every penetration, with roofing felt across the field. This is the layer that actually keeps South Florida rain out of your attic.
New roof flashing at walls, chimneys and valleys, plus fresh pipe boots and sealant at every penetration. Old flashing is where most roof leaks start, so we never reuse it.
We install ridge vents, off-ridge vents and matching ridge caps so your attic breathes. Poor attic ventilation cooks shingles from underneath and shortens roof life by years.
We pull the Miami-Dade County permit in our name, meet the inspector on site, and register your manufacturer warranty after final payment. You get the paperwork in your inbox.
We walk the roof, check the deck from the attic, and run a moisture meter and infrared camera on any suspect ceiling stains. You get photos of every problem area plus a written scope. Takes 45 to 60 minutes.
Same day or next morning, you receive a line-item quote: tear-off, decking, underlayment, material brand, flashing, ventilation and disposal. We price repair and full replacement side by side so you can see the real difference.
We order your shingles, metal panels or clay tiles and schedule delivery the day before the crew arrives. Bundles stay covered and off the grass. You get a text with the delivery window and the crew's start time.
Crews strip the old roof, replace rotted sheathing, lay ice and water shield and roofing felt, then install the field, flashing and ridge. Most homes take two to three days; tile and slate run four to six.
We magnet-sweep the yard, haul off debris, and walk the finished roof with you. You get the manufacturer warranty registration, permit sign-off and photos of the nailing pattern for your records.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Drives ring-shank nails at the manufacturer's specified pattern for wind-uplift ratings. We check depth and placement on every pass.
Strips old shingles and felt without gouging the decking, so we can see the true condition of the sheathing underneath.
Sets straight courses on shingle roofs and trims metal flashing and drip edge cleanly at valleys and walls.
Finds hidden leaks and wet decking from inside the attic, so we repair the source rather than the ceiling stain.
OSHA-compliant fall protection on every pitched roof. Our crews are OSHA 10 and OSHA 30 certified.
Cuts underlayment and ice and water shield to fit, then seals every penetration and flashing edge with manufacturer-approved sealant.
A 1,900-square-foot ranch home with a 21-year-old three-tab shingle roof. Missing shingles along the ridge, two cracked pipe boots and soft decking around the chimney. The homeowner had two active ceiling stains.
Full tear-off, four sheets of decking replaced, new ice and water shield, GAF Timberline shingles and new pipe boots. Completed in two and a half days. The ceiling stains stopped after the first rain.
A 2,400-square-foot waterfront home with a failing shingle roof and rusted fasteners from salt exposure. The owner wanted a roof that would outlast the mortgage and hold up to hurricane wind.
Standing-seam metal roofing panels installed over new underlayment with concealed clips and NOA-approved fastening. Five days on site. Wind uplift rating meets Miami-Dade County code, and the attic runs 15 to 20 degrees cooler.
A 3,100-square-foot tile roof with original 1990s underlayment that had failed. The tile was still good, but water was reaching the decking through cracked felt and deteriorated valley flashing.
We lifted and stacked the existing clay tiles, replaced the underlayment and valley flashing, replaced 11 cracked tiles and re-laid the roof. Six days total. No leaks through the following rainy season.
South Florida roofs fail in predictable ways. These are the calls we get most from Cutler Bay homeowners, and what happens if you let them sit.
Ask a pro →We tarp the exposed area the same day, then match and install replacement shingles once the storm passes. If the field is more than 20 percent damaged, we price a full re-roof so you can compare.
We pull the old flashing, inspect the deck for rot, and set new metal flashing with proper counter-flashing and sealant. Most flashing repairs run $450 to $1,200 depending on access.
We replace every cracked boot with a new neoprene or lead boot and reseal the base. It is a $200 to $400 fix that prevents a $3,000 decking repair.
We clear the drains, re-slope or add tapered insulation where needed, and reseal the seams. For roofs past their service life, we install a new TPO or modified bitumen membrane.
Most full re-roofs in Cutler Bay run $9,500 to $24,000 in 2026, depending on size and material. Asphalt shingle averages $5.50 to $8.50 per square foot installed; standing-seam metal runs $12 to $18; clay or concrete tile runs $14 to $22. Tear-off, decking repair and disposal are separate line items, so ask for a breakdown, not a single per-square number.
They strip the old roof, inspect and replace damaged sheathing, then install underlayment, ice and water shield, flashing and the finished roof surface. In Cutler Bay that also means fastening to Miami-Dade County NOA wind-uplift specs and setting pipe boots and valley metal correctly. The install is the whole system, not just the shingles you see from the street.
Ask three things before you sign: the Florida Roofing License (RR) number, a certificate of insurance, and the manufacturer name on the shingles. Then get a written scope listing tear-off, underlayment, flashing and disposal. We give same-day estimates and will walk you through repair versus replacement with photos of your actual roof.
Yes - roofing is a licensed trade in Florida, and any legitimate installer holds a state Roofing License (RR). Ask to see it, and check that the permit is pulled in the company's name. Our crews also carry OSHA 10 and OSHA 30 certifications and install to Florida Building Code, which is what your insurance carrier will look for after storm damage.
Same-day estimates, licensed and insured crews, and manufacturer warranties registered in your name. Call (855) 960-5906 and we will walk your roof, show you the photos and give you a straight repair-or-replace answer.
Get Free Estimate (855) 960-5906 →Call (855) 960-5906 any time, day or night, and a real person picks up. For non-emergencies, we schedule free inspections Monday through Friday and can usually get to your property within 24 to 48 hours. If you have photos of the damage, text or email them over and we will take a look before we arrive.